Additive manufacturing allows for a great degree of design freedom and is rapidly becoming a mainstream manufacturing process. However, as in all manufacturing processes, it has its limitations and specificities. Equipping engineers with this knowledge allows for a higher degree of optimization, extracting the most out of this technology. Therefore, a specific part design was devised and created via L-PBF (Laser Powder Bed Fusion) using AlSi10Mg powder. Certain parameters were varied to identify the influence on material density, hardness, roughness, residual stress and microstructures. It was found that on heat treated parts laser pattern strategy is one of the most influential aspects, showing that chessboard and stripes 67° improved outcome; average Ra roughness varied between 8-12 μm, residual stress was higher on vertical surfaces than horizontal surfaces, with the combination of support structures and stripes 67° strategies generating the lowest residual stress (205 MPa on a lateral/vertical face), hardness was non-orientation dependent and larger on samples with chessboard fabrication strategies, while microstructures were composed of α-Al dendrites surrounded by Si particles. The distribution and grain size of the microstructure is dependent on location regarding melt pool and HAZ area. Furthermore, Al-Mg oxides were encountered on the surface, along with pores generating from lack of fusion.
Effect of scan strategies and use of support structures on surface quality and hardness of L-PBF AlSi10Mg parts / Gouveia, R. M.; Silva, F. J. G.; Atzeni, E.; Sormaz, D.; Alves, J. L.; Pereira, A. B.. - In: MATERIALS. - ISSN 1996-1944. - ELETTRONICO. - 13:10(2020), p. 2248. [10.3390/ma13102248]
|Titolo:||Effect of scan strategies and use of support structures on surface quality and hardness of L-PBF AlSi10Mg parts|
|Data di pubblicazione:||2020|
|Digital Object Identifier (DOI):||http://dx.doi.org/10.3390/ma13102248|
|Appare nelle tipologie:||1.1 Articolo in rivista|