In this paper the effect of vibration on the Tank + Sender Unit for urea SCR sys-tem is presented performing a comparison between experimental tests and finite element analysis, considering the vibrations spectra to which the vehicle is sub-jected during its operation. A first tank material experimental characterization was performed, using the Oberst’s beam technique, to evaluate Young's Modulus and Loss Factor and develop a material card. The comparison between experimental and virtual frequency response on beam allows to validate material characteristics to develop the full tank model for the entire system (Tank + Sender Unit). Then, a vibrational experimental analysis has been performed, with four different filling level (0%, 25%, 50% and 75%), positioning 4 accelerometers at the external part of the system, using a frequency range from 2 to 200 Hz. For each condi-tion, the experimental modes shapes and natural frequency have been compared with the finite element simulation results.
NVH Analysis of a Urea-SCR and Sender Unit System for Truck Vehicle / Carello, M., Berti Polato, D., Bolzoni, M.. - ELETTRONICO. - 219:(2026), pp. 537-547. (IFIT 2026 - 6th International Conference of IFToMM Italy Foligno 9-11 Settembre 2026) [10.1007/978-3-032-35970-4_57].
NVH Analysis of a Urea-SCR and Sender Unit System for Truck Vehicle
Massimiliana Carello;
2026
Abstract
In this paper the effect of vibration on the Tank + Sender Unit for urea SCR sys-tem is presented performing a comparison between experimental tests and finite element analysis, considering the vibrations spectra to which the vehicle is sub-jected during its operation. A first tank material experimental characterization was performed, using the Oberst’s beam technique, to evaluate Young's Modulus and Loss Factor and develop a material card. The comparison between experimental and virtual frequency response on beam allows to validate material characteristics to develop the full tank model for the entire system (Tank + Sender Unit). Then, a vibrational experimental analysis has been performed, with four different filling level (0%, 25%, 50% and 75%), positioning 4 accelerometers at the external part of the system, using a frequency range from 2 to 200 Hz. For each condi-tion, the experimental modes shapes and natural frequency have been compared with the finite element simulation results.Pubblicazioni consigliate
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
https://hdl.handle.net/11583/3018122
Attenzione
Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo
