Experimental Study on the Effect of Bonding Area Dimensions on the Mechanical Behavior of Composite Single-Lap Joint with Epoxy and Polyurethane Adhesives

The effects of joint geometry parameters, such as adherend thickness (1.76, 3.52 mm), joint width (10, 20, 30 mm), and overlap length (10, 20 mm), on the behavior of single-lap joints (SLJs) under tensile loading are investigated in this study. Peak force, joint stiffness, shear stress, and normal stress are the investigated properties. SLJs are manufactured with carbon fiber composite adherends and two different types of adhesives, polyurethane and epoxy, which present a flexible and rigid mechanical response. The results showed that increasing all 3 geometric parameters (L, W, T) leads to a significant increase in the load capacity of polyurethane joints (on average, 88.4, 101.5, and 16.9%, respectively). For epoxy joints, these increases were 47.7, 100, and 46%, respectively. According to these results, W is the parameter with the most influence on the load capacity of the joints. However, it was observed that an increase in joint width has no significant effect on adhesive shear and a substrate’s normal stresses. Epoxy SLJs behave approximately elastically until failure, while polyurethane SLJ load-displacement curves include an initial linear elastic part followed by a more ductile behavior before the failure. Joint stiffness is affected by all the parameters for both adhesive types, except for overlap length, which led to a negligible effect on epoxy joints. Moreover, the damage surfaces for both types of joints are analyzed and the internal stresses (shear and peel) are assessed by using the analytical model of Bigwood and Crocombe