Infrared thermography of transition due to isolated roughness elements in hypersonic flows

Boundary layer transition in high-speed flows is a phenomenon that despite extensive research over the years is still extremely hard to predict. The presence of protrusions or gaps can lead to an accelerated laminar-to-turbulent transition enhancing the thermal loads and the skin friction coefficient. In the current investigation, inverse heat transfer measurements using infrared thermography are performed on the flow past different roughness geometries in the form of cylinders and diamond at free stream Mach number equal to 7.5, h/d ranging between 0.5 and 0.9 (where h is the roughness height and delta is the boundary layer thickness), and Re. ranging between 1305 and 2450. The roughness elements are positioned on a 5 degrees ramp placed at zero angle of attack. The measurements indicate that the roughness geometry influences the transitional pattern while the frontal area influences both the transition location and the maximum value of the Stanton number along the centreline. Moreover, there is a strong connection between the streamwise centreline Stanton number and the spreading of the wake width. In particular, the transition process is characterized by an approximately constant wake width. Differently, the wake width spreads at the location where the streamwise centreline Stanton number reaches the turbulent level. This point corresponds to a local maximum of the wake amplitude defined as one half of the maximum spanwise variation of the Stanton number. (C) 2016 AIP Publishing LLC.