Archivio Istituzionale della RicercaIn the field of noise control and monitoring, a new generation of small and low-cost microelectro-mechanical system (MEMS) microphones is nowadays widely adopted. MEMS microphones, after recognition as traceable measurement instruments, could open up promising measurements based on wireless sensor networks. Current standards do not apply specifically to digital microphones. In this work, a pressure calibration procedure by comparison is carried out for a digital MEMS microphone and a sensitivity parameter suitable for metrological purposes is proposed. Measurement procedure and results between 20 Hz and 20 kHz are presented along with uncertainty contributions.
Pressure calibration of a digital microelectromechanical system microphone by comparison / Prato, A.; Montali, N.; Guglielmone, C.; Schiavi, A.. - In: THE JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA. - ISSN 0001-4966. - 144:4(2018), pp. EL297-EL303. [10.1121/1.5059333]
Pressure calibration of a digital microelectromechanical system microphone by comparison
Prato A.;Schiavi A.
2018
Abstract
In the field of noise control and monitoring, a new generation of small and low-cost microelectro-mechanical system (MEMS) microphones is nowadays widely adopted. MEMS microphones, after recognition as traceable measurement instruments, could open up promising measurements based on wireless sensor networks. Current standards do not apply specifically to digital microphones. In this work, a pressure calibration procedure by comparison is carried out for a digital MEMS microphone and a sensitivity parameter suitable for metrological purposes is proposed. Measurement procedure and results between 20 Hz and 20 kHz are presented along with uncertainty contributions.
Pubblicazioni consigliate
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
https://hdl.handle.net/11583/2961808