This paper presents a very low-complexity all-digital IR-UWB transmitter that can generate pulses in the band 0–5 GHz, requiring a silicon area lower than a PAD for signal I/O. The trans- mitter, suited to non-standardized low data rate applications, is prototyped in a 130 nm RFCMOS technology and includes analog control signals for frequency and bandwidth tuning. Center fre- quency is linearly selected with voltage supply, 0.5 V for the range 0–960 MHz and 1.1 V supply for the higher 3.1–5 GHz range. The architecture is based on the same delay cell for both baseband and radio frequency signal generation and pulses fractional bandwidth remains constant when voltage supply and control voltages scale. At 420 MHz center frequency, the transmitter achieves 7 pJ/pulse, and for 4 GHz center frequency pulses, it achieves 32 pJ/pulse ac- tive energy consumption. The OOK/S-OOK transmitter occupies an area of 0.004 mm . For ASK modulation, the system includes a separate on-chip capacitor bank connected to the output of the transmitter for an overall size of 0.024mm2. For pulse rates below 100 kpps, the generated pulses meet the FCC indoor mask with an off-chip DC block capacitor. The paper also presents over-the-air measurements using a planar monopole antenna operating in the 1.5–3.7 GHz frequency range.

A Very Low-Complexity 0.3–4.4 GHz 0.004 mm2 All-Digital Ultra-Wide-Band Pulsed Transmitter for Energy Detection Receivers / Crepaldi, Marco; Dapra', Davide; Bonanno, Alberto; I., Aulika; Demarchi, Danilo; Civera, Pierluigi. - In: IEEE TRANSACTIONS ON CIRCUITS AND SYSTEMS. I, REGULAR PAPERS. - ISSN 1549-8328. - STAMPA. - 59:10(2012), pp. 2443-2455. [10.1109/TCSI.2012.2188954]

A Very Low-Complexity 0.3–4.4 GHz 0.004 mm2 All-Digital Ultra-Wide-Band Pulsed Transmitter for Energy Detection Receivers

CREPALDI, MARCO;DAPRA', DAVIDE;BONANNO, ALBERTO;DEMARCHI, DANILO;CIVERA, PIERLUIGI
2012

Abstract

This paper presents a very low-complexity all-digital IR-UWB transmitter that can generate pulses in the band 0–5 GHz, requiring a silicon area lower than a PAD for signal I/O. The trans- mitter, suited to non-standardized low data rate applications, is prototyped in a 130 nm RFCMOS technology and includes analog control signals for frequency and bandwidth tuning. Center fre- quency is linearly selected with voltage supply, 0.5 V for the range 0–960 MHz and 1.1 V supply for the higher 3.1–5 GHz range. The architecture is based on the same delay cell for both baseband and radio frequency signal generation and pulses fractional bandwidth remains constant when voltage supply and control voltages scale. At 420 MHz center frequency, the transmitter achieves 7 pJ/pulse, and for 4 GHz center frequency pulses, it achieves 32 pJ/pulse ac- tive energy consumption. The OOK/S-OOK transmitter occupies an area of 0.004 mm . For ASK modulation, the system includes a separate on-chip capacitor bank connected to the output of the transmitter for an overall size of 0.024mm2. For pulse rates below 100 kpps, the generated pulses meet the FCC indoor mask with an off-chip DC block capacitor. The paper also presents over-the-air measurements using a planar monopole antenna operating in the 1.5–3.7 GHz frequency range.
File in questo prodotto:
Non ci sono file associati a questo prodotto.
Pubblicazioni consigliate

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11583/2498562
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo